Diy wooden key holder for wall12/27/2023 For the Wood Key Holder: Sand the 1×2 Board: Depending on the cut of wood, you. Stained each of these pieces in Minwax English Chestnut and finished them with two coats of Minwax Polyurethane in Semigloss. I also attached the d-ring hardware on the back before doing any work to the front. Normally making a wall-mounted key holder with key chain slots & recessed. As a reminder, my key rack measurements were 19 inches by 7.5 inches (it was a piece of 1×8) and 8 inches by 2.5 inches. Read my full terms of use here.) Step 1: Cut and stain woodįirst I cut my two pieces and sanded them. Do not use any tools without proper training, precautions, and supervision from a professional. Follow the directions and warnings from your particular brand. (Remember to wear a mask and eye protection while sanding and working with wood, and wear an appropriate mask while working with paints, stains, and finishes.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |